Elmdene 24Vdc 10A + 0.7A Switch Mode PSU EN54 Approved (2 x 17Ah Batteries)

Description

Elmdene 24Vdc 10A + 0.7A Switch Mode PSU EN54 Approved (2 x 17Ah Batteries)

The STX2410 is an EN54-4 approved power supply ideal for use in Fire control Systems. Its regulated 27.6V dc output will supply a total of 10 Amps continuous into the load, whilst also enabling battery charging. (7.2 Amps Load with 65Ah batteries, 10 Amps with 18Ah batteries).

The power supply output features electronic short circuit protection under both mains and standby battery operation. Maximum battery life is assured through continuous active battery monitoring and the use of a three stage charger, comprising bulk, absorb and temperature compensated final float phase depending upon battery condition.

Once fully charged the product operates in Eco power saving mode, whereby it will check and top up battery charge every 2 hours, but will not waste energy by continuously attempting to charge a fully charged battery. This also extends the operating life of the battery. Deep discharge protection prevents premature battery failure when operating from standby for extended periods.

Key Features:

Certified by UL to EN54-4:1997 +A1: 2002 + A2: 2006.

Up to 10 A current to load at 27.6V dc nominal regulated output.

Charging capability to support 18, 38 or 65Ah batteries with intelligent load enhancement.

Electronic overload protection shuts down output until overload or short circuit is removed.

Battery Monitor detects battery missing, low battery, short-circuit or reverse connection.

Battery charging circuit is energised only when a battery is correctly connected and the battery voltage is greater than 14 V.

No loss of output during automatic connection of battery to load on loss of mains.

Deep discharge protection disconnects battery from load when battery voltage falls to 21 V.

Fault indicator LED (Yellow) flashes on detection of output fault, battery fault, charger fault and mains failure.

Mains indicator LED (Green) showing mains present.

RS232 serial interface for fault reporting and diagnostics interface to OEM equipment.

Suitable to fit batteries up to 2 x 17Ah

‘E’ Box Power Supply – 420h x 400w x 80d (mm)

Hinged Lid

Can use BATT-BOX-65 to make product 7.2a load + 2.6a battery charging with 2 x 65Ah Batteries