-
Product Description The Edwards EST / GE F-XTR120 NAC Power Expander Transformer is intended for use with 10-zone, 120VAC F-Series fire alarm control panels. p/n 3101035 -
Product Description The Edwards EST F-DACT is a digital alarm communicator transmitter for use with F-series fire alarm control panels. The F-DACT can be programmed to operate as a single or dual line DACT/Modem/LCD display, a Modem/LCD display, or an LCD display only.
-
Product Description The Edwards EST1-1Z1 is a Single Zone conventional Fire Alarm Control Panel.
-
Product Description The Edwards EST ESD-SJ SuperDuct Duct Smoke Detector is a four-wire smoke sensor with RJ-45 modular connector for use with SuperDuct Series Duct Smoke Detectors.
-
Product Description The Edwards EST ESD-4WJ SuperDuct Four-Wire Duct Smoke Detector is a combination four-wire controller and sensor with RJ-45 modular connectors. COMPATIBLE ACCESSORIES: — SD-T8 Air sample tube, 8 inch — SD-T18 Air sample tube, 18 inch — SD-T24 Air sample tube, 24 inch — SD-T36 Air sample tube, 36 inch — SD-T42 Air sample tube, 42 inch — SD-T60 Air sample tube, 60 inch — SD-T78 Air sample tube, 78 inch — SD-T120 Air sample tube, 120 inch — SD-RJ15 RJ45 wiring harness kit -- 15 ft. — SD-RJ10 RJ45 wiring harness kit -- 10 ft. — SD-RJ5 RJ45 wiring harness kit -- 5 ft. — SD-TRM4 Remote test/reset station, magnetic — SD-TRK4 Remote test/reset station, keyed — 5956A Remote LED Alarm Indicator
-
Product Description The Edwards EST EGCF-VM is a Genesis Ceiling Strobe, 15 to 95 multi-cd, white, with FIRE marking.
-
Product Description Edwards EST EG4F-S7 70-volt Speaker (White) is part of the Genesis G4 Series of Speakers and Strobes.
-
-
Product Description NOTE: This part is discontinued by the manufacturer. No direct replacement is available. The EST EC30U-3 is a low-profile plug-in photoelectric detector is part of EST's EC Series of low-profile plug-in smoke and heat detectors. COMPATIBLE BASES sold separately: — CSBU-1 Standard detector base — CSB4U-1 4" standard detector base — CRB4U-1 4" relay detector base, 1.25A @ 30 Vdc
-
Product Description The Edwards EST EC-30DU-3 is a Photoelectric Duct Smoke Detector designed for use with 6260A-CU Duct Smoke Detector Housing. Operating Voltage Range: 14 - 30 VDC COMPATIBLE BASES and ACCESSORIES: — CRB4U-1 Detector Relay Base — CSBU-1 Detector Standard Base — CSBU-3 Detector Resistor Base — 6263-EC Air Velocity Test Kit — EC-LED Fire Alarm LED Indicator — C-DTS Fire Alarm LED/Test Station
-
Product Description Edwards EST EC20RRU-3 Heat Detector
-
Product Description Edwards EST EC-LLT Low Level Tester
-
Product Description Edwards EC-LED Remote Alarm Indicator
-
Product Description Edwards EC-100R Beam Detector Unit
-
Product Description The Edwards E-PD Intelligent Analog Optical Smoke Detector uses rotary switches to set address. COMPATIBLE BASES and ACCESSORIES: — B4U Standard Base — RB4U Relay Detector Base — IB4U Isolator Detector Base — SB4U Audible (Sounder) Detector Base — AB4G-SB Surface Box for Audible Base — RLED Remote alarm LED, use with standard base only — 211-10PKG Replacement optical chambers
-
Product Description The Edwards EST E-NAC Analog NAC Module is an analog addressable device used to connect a supervised output circuit to a signal riser. The output wiring is monitored for open and short circuits. A short circuit causes the module to inhibit the activation of the audible/visual signal circuit so the riser is not connected to the wiring fault. Upon command from the control panel, the module connects the output circuit to the riser input. The output circuit energizes a riser to operate polarized audible and visual signals. The module can be used for connection of a Class A or Class B (with EOL) output notification appliance circuit (NAC). The device address is set using the two rotary switches located on the front of the module. One device address is required.
-
Product Description The Edwards E-IDC1B Analog Single Input Mini Module connects a normally open, alarm, supervisory, or monitor type dry contact initiating device circuit (IDC) to the Edwards Signaling control panel. For Class B circuit operation.
-
Product Description Edwards E-IDC1A Analog Class A Single Input Module is an analog addressable device used to connect a normally open, alarm, supervisory, or monitor type dry contact initiating device circuit (IDC) to a control panel. This module is designed for Class A circuit operation. The device address is set using the two rotary switches located on the front of the module. One device address is required. The device can be preset for alarm or supervisory operation using the slide switch located on the front of the module. The module can also be configured for other device types through front panel programming or the configuration utility.
-
Product Description The Edwards E-270 Addressable Manual Pull Station is a normally open dry contact initiating device that requires one action by the user to initiate an alarm. Rotary Addressing for use with Edwards Signalling intelligent systems.
-
Product Description NOTE: This part is discontinued by the manufacturer. There is no designated replacement. The Edwards DLD Dual Line Dialer provides two telephone line connections for transmitting system status changes to one or two compatible digital alarm communicator receivers (DACRs) over the public switched telephone network. For use with QS FACPs.
-
Product Description Edwards EST DHS-1224C Chrome Door Holder
-
Product Description The Edwards EST CSBU-3 is a plug-in Detector Base (w/ Resistor) is intended for use with the EC Series of low-profile plug-in smoke and heat detectors from Edwards EST.
-
Product Description Edwards EST's CSBU-1 Standard Detector Base is designed for use with Edwards / EST's EC Series Smoke and Heat Detectors. Provides plug-in tamper-resistant mounting. Includes screw terminals for connection of installation wires. COMPATIBLE EC SERIES DETECTOR HEADS: — EC30U-3 Low-profile plug-in Photoelectric Detector — EC10C-3 Low-profile Plug-in Ionization Detector — EC20FTU-3 Low-profile Plug-in Fixed Temperature Heat Detector — EC20RRU-3 Low-profile Plug-in Rate-of-Rise Heat Detector COMPATIBLE ACCESORIES: — C-TRIM Trim skirt for CSBU-1 base — EC-LED Remote alarm LED indicator
-
Product Description Edwards CS2002-11 Manual Yellow Pull Station
