Key Features:; Unlike UV and UV/IR detection, not blinded by oil mist in machinery spaces Reduces cabling, no interface required No additional power source required Easy installation uses a common plug in base for smoke and heat detectors Can be used on all vessels as fully marine approved

Key Features:; Over 20 fire detection modes Tyco MX FASTLOGIC Expert algorithms MX HPO detection Algorithms Up to 250 detectors per loop Remote detector verification & temperature read out Programmable alarm LED with 360o viewing angle Optional detector locking pin Variety of sounder and relay detector bases Address flag stays with the base Approved by all major classification societies for use on vessels Lower cost system design and installation as one detection type can be used throughout the vessel Lower cost of ownership as no radioactive source disposal costs together with less spares holding Enhanced safety in accommodation areas by using the unique Carbon Monoxide (CO) detectors Major Cable saving options using loop powered ancillaries Allows easier decision making by operator because of remote temperature and smoke density read-out

Advanced multi-sensor designs Built-in line isolator (850PH Only) Quick and easy to install Extended drift compensation Two way infra-red communication to the 850EMT Engineering Management Tool Fire, isolate and fault LED indications Any Pantone colour available with CPD approval

Advanced multi-sensor designs Built-in line isolator (850PH Only) Quick and easy to install Extended drift compensation Two way infra-red communication to the 850EMT Engineering Management Tool Fire, isolate and fault LED indications Any Pantone colour available with CPD approval

Features; Conventional I.S. system Suitable for worst case (EEx ia IIC T5) High Performance Optical (HPO) smoke detector Compatible with S231i+ flame detector Compatible I.S. callpoint Suitable for use in Zone 0,1,2,20,21& 22 Polyester Enclosure - light, strong and not subject to corrosion. Break Glass. Explosion protected EExe (ATEX Approved). In line and end of line resistors. Red. 9 x terminals. Lift flap for extra protection against inadvertent operation. 1 x changeover switch. Captive cover screws. No hammer required - the glass is covered by a membrane thus protecting the operator from glass fragments. Key operated test facility - simple but secure. 2 x M20 bottom cable entries.