-
Key Features:; 2 and 4 amp versions available Features a green LED to indicate mains present Features amber LED to indicate a fault -
Key Features:; 2 and 4 amp versions available Features a green LED to indicate mains present Features amber LED to indicate a fault
-
-
Key Features:; Weatherproof version (IP65) Low power consumption LED’s Choice of flash frequency Choice of power settings Choice of cable entry positions Low power requirement Selectable flash frequency Selectable flash intensity
-
-
Simple to install Fits onto standard single gang back box Wide viewing angle high brightness LED Attractive styling; Can be remote mounted Controlled by the panel Can be activated by cause and effect Reduced cost Minimises cabling
-
-
Quick and simple to install Simple two wire connection No power supply required; Benefits; Single device to install instead of numerous point detectors Single point of maintenance Wall mounted for ease of maintenance
-
Quick and simple to install Simple two wire connection No power supply required; Benefits; Single device to install instead of numerous point detectors Single point of maintenance Wall mounted for ease of maintenance
-
-
Double pole change over contacts Visible status indication LED Simple to install; Low current consumption 230V ac rated contacts Will switch up to 10A (resistive)
-
Key Features:; High efficiency design LED technology Low profile design; Low current High efficiency LED / visual unit suitable for DDA compliance
-
Loop powered Soft addressed Integral short circuit Isolator Single address Reflective beam detection Quick and simple to setup Saves on both time and installation costs No power supply required Single device to install instead of numerous point detectors Single point of maintenance Wall mounted for ease of maintenance, especially in warehouses with racking; 1 x Detector Head Assembly 1 x Prism for the MAB50R 1 x Dual Test Filter 1 x 4-way Connector for in line wiring 1 x 4-way Connector for right angle wiring
-
Loop powered Soft addressed Integral short circuit Isolator Single address Reflective beam detection Quick and simple to setup Saves on both time and installation costs No power supply required Single device to install instead of numerous point detectors Single point of maintenance Wall mounted for ease of maintenance, especially in warehouses with racking; 1 x Detector Head Assembly 4 x Prism for the MAB100R 1 x Dual Test Filter 1 x 4-way Connector for in line wiring 1 x 4-way Connector for right angle wiring
-
Ultra-low current consumption of 10mA Up to 7.5m coverage volume 0.5Hz or 1Hz flash rate Coverage switch to 2.5m on the wall variant and 3m on the ceiling variant. Use where current consumption is a key consideration Ideal for bedrooms, bathrooms and toilets Switch flash rate to 0.5Hz to reduce current consumption Reduces power consumption by up to 50%
-
Facility for signalling to repeater panel provided as standard on 8 zone panel Surface or semi-flush mounting Displays essential information at other key locations in a large building/site Displays zone fire and fault conditions; Repeater matches the style and appearance of the control panel Requires only a single pair of wires to receive signals from control panel reducing cost of installation
