Product Description This is the replacement board for the EST Fireshield FS1004 (10-zone) fire alarm control panel; supports 10 initiating device circuits and 4 notification appliance circuits. Panel is configured for Class B operation. Can be converted to Class A by using two Class B circuits to make one Class A circuit. COMPATIBLE (OPTIONAL) ACCESSORIES: — Remote System Indicator (FSRSI) — Remote Zone Indicator (FSRZI-A) — Remote Relay Module (FSRRM) — Power Expander Transformer (XTR3A120, XTR3A230) — DACT (Dialer)/Modem (FSDACT) — City Tie Module (CTM4.7) — Reverse Polarity Module (RPM) — Battery Cabinet (BC-2)

Product Description The Edwards EST / GE F-XTR120 NAC Power Expander Transformer is intended for use with 10-zone, 120VAC F-Series fire alarm control panels. p/n 3101035

Product Description The Edwards EST ESD-4WJ SuperDuct Four-Wire Duct Smoke Detector is a combination four-wire controller and sensor with RJ-45 modular connectors. COMPATIBLE ACCESSORIES: — SD-T8 Air sample tube, 8 inch — SD-T18 Air sample tube, 18 inch — SD-T24 Air sample tube, 24 inch — SD-T36 Air sample tube, 36 inch — SD-T42 Air sample tube, 42 inch — SD-T60 Air sample tube, 60 inch — SD-T78 Air sample tube, 78 inch — SD-T120 Air sample tube, 120 inch — SD-RJ15 RJ45 wiring harness kit -- 15 ft. — SD-RJ10 RJ45 wiring harness kit -- 10 ft. — SD-RJ5 RJ45 wiring harness kit -- 5 ft. — SD-TRM4 Remote test/reset station, magnetic — SD-TRK4 Remote test/reset station, keyed — 5956A Remote LED Alarm Indicator

Product Description Edwards EST EG4F-S7 70-volt Speaker (White) is part of the Genesis G4 Series of Speakers and Strobes.

Product Description Edwards EC-LED Remote Alarm Indicator

Product Description The Edwards EST E-NAC Analog NAC Module is an analog addressable device used to connect a supervised output circuit to a signal riser. The output wiring is monitored for open and short circuits. A short circuit causes the module to inhibit the activation of the audible/visual signal circuit so the riser is not connected to the wiring fault. Upon command from the control panel, the module connects the output circuit to the riser input. The output circuit energizes a riser to operate polarized audible and visual signals. The module can be used for connection of a Class A or Class B (with EOL) output notification appliance circuit (NAC). The device address is set using the two rotary switches located on the front of the module. One device address is required.