-
Allows the 801/802/812/901 & 912 Sounder Base to become Addressable without the need to fit a Detector, thus creating an Addressable Loop Powered Sounder Suitable for wall or ceiling mounting Sounder Selection Tones as per 801/802/812/901 & 912 Sounder Base Fits the 801RB Relay Base to provide an Addressable Relay Base without the need to fit a Detector Colour matched to Sounder Bases Locked into Sounder Base using Detector Locking Pin SAM 800 is configurable in CONSYS SAB800 / SAB801 may be used with 5B or MUB bases SAB800 / SAB801 adds a Flashing Red Beacon facility to the 801/802/812/901 & 912 Sounder Base SAB801 Low current consumption (loop powered) SAB800 has two Modes of Operation - continuous or 2Hz flash, configurable in CONSYS SAB801 has two Modes of Operation - continuous or 1Hz flash , configurable in CONSYS -
Ziton ZP755B-2W Addressable Sounder Base (White); Sensor and sounder from a single wiring point - minimising installation costs Powered directly from the ZP loop Up to 60 sensor/sounders directly on the loop Separate addresses selectable for sensor and sounder High efficiency sound gun transducer Compatible with all ZP loop devices Wide range of international sound types and frequencies
-
Sensor, sounder and beacon from a single wiring point - minimising installation costs Powered directly from the ZP loop Separate addresses selectable for sensor and sounder beacon Up to 40 units directly on the loop High efficiency sound gun transducer Plug in base - no internal connections Wide range of international sound types and frequencies
-
Loop Powered - Reduced installation costs High Output / Low consumption - Lower lifetime costs Indoor and Outdoor models - Same sounder tones in all areas Sounder / LED Beacon Version - DDA Compliant 16 Tones and 2 Flash rates - Suites individual requirements Reflective Sound Monitoring RSM - Reassurance that ALL sounders are working Integral Line Isolator - Saves cost and installation time
-
Loop Powered - Reduced installation costs High Output / Low consumption - Lower lifetime costs Indoor and Outdoor models - Same sounder tones in all areas Sounder / LED Beacon Version - DDA Compliant 16 Tones and 2 Flash rates - Suites individual requirements Reflective Sound Monitoring RSM - Reassurance that ALL sounders are working Integral Line Isolator - Saves cost and installation time
-
MX LPAV3000 Loop Powered Sounder/Beacon - Addressable Base; High output programmable sounder base and sounder beacon base One point of installation for detector, isolator, sounder & beacon Loop powered from the MX Technology® Digital Loop High brightness Multi-LED Beacon Software programmable 15 Tones and 2 Flash Rates Integral line isolator RSM (Reflective Sound Monitoring) Can be used as a standalone device using the sounder blanking cap
-
-
Loop Powered - Reduced installation costs High Output/Low consumption - Lower lifetime costs Indoor and Outdoor models - Same sounder tones in all areas Sounder/LED Beacon Version - DDA Compliant 16 Tones and 2 Flash rates - Suits individual requirements Reflective Sound Monitoring RSM - Reassurance that ALL sounders are working Integral Line Isolator - Saves cost and installation time; Models Available
-
-
Features; Manufactured to EN54 part 3 Integral sounder and detector base Volume and tone adjustable after installation Low Power Synchronisation Do not require use of a standard base (maybe installed directly onto a standard besa box)
-
Key Features:; 4 pre-set message pairs, capable of up to 15 tone message pairs Low current and high volume Fully synchronised Set up and test at point of installation
-
High Intensity LED technology 1Hz flash frequency Addressable via Hand Held Programmer (TCH-B100) Up to 127 devices per loop Low current consumption Available in 3 lens colours Approved by VdS
